Hey,
I'm trying to setup Vireio for Mirror's Edge using SHOCT + the guide, but I have a weird issue.
I start by pressing F6, since I'm pretty sure the eyes are swapped. But it makes it so I can't follow the rest of the guide. I align the SHOCT lines then try to raise the separation (F3), but because of the swap, doing so make them move farther away from each others instead of making them close up.
How should I proceed?
Configuration issue because of swapped eyes?
-
- One Eyed Hopeful
- Posts: 20
- Joined: Thu Jan 29, 2009 5:01 pm
- Neil
- 3D Angel Eyes (Moderator)
- Posts: 6882
- Joined: Wed Dec 31, 1969 6:00 pm
- Contact:
Re: Configuration issue because of swapped eyes?
Sorry for the late response; I've been traveling.
Did you set the red SHOCT lines according to what you perceive as the center of your eyes? Unless this step is done, the rest won't work.
Regards,
Neil
Did you set the red SHOCT lines according to what you perceive as the center of your eyes? Unless this step is done, the rest won't work.
Regards,
Neil