Hi Guys!
I'm working on building a good test bed, and I need a hardware switcher that will let me hook a single computer up to more than one S-3D monitor/HMD solution.
However, while I find a lot of devices to hook up multiple computers to a single monitor, it's hard to find something the other way around. Any ideas? Product names?
Thanks in advance,
Neil
DVI/VGA Monitor Switcher Needed
- Neil
- 3D Angel Eyes (Moderator)
- Posts: 6882
- Joined: Wed Dec 31, 1969 6:00 pm
- Contact:
- Likay
- Petrif-Eyed
- Posts: 2913
- Joined: Sat Apr 07, 2007 4:34 pm
- Location: Sweden
Try googling for "vga-splitter". best tip i have.
for example here i have: http://www.okit.se/html/aten_vga-splitt ... .2061.html
cheers
for example here i have: http://www.okit.se/html/aten_vga-splitt ... .2061.html
cheers
- Znith
- Cross Eyed!
- Posts: 107
- Joined: Sun Apr 15, 2007 1:32 pm
I'm looking for a similar setup until my 8800 is fully supported.
I asked my IT dept. at work and they said to get a KVM switch and clone the monitor. I'm not exactly sure they understood my question and since I don't have a kvm switch I can't try it. Somehow I don't think this would work.
I asked my IT dept. at work and they said to get a KVM switch and clone the monitor. I'm not exactly sure they understood my question and since I don't have a kvm switch I can't try it. Somehow I don't think this would work.
IZ3D~ My answer to S3D!
- LukePC1
- Golden Eyed Wiseman! (or woman!)
- Posts: 1387
- Joined: Wed May 16, 2007 11:30 am
- Location: Europe
- Contact:
Are the 3D displays supposed to have different output formats?
If all were e.g. side by side or over under or Pageflipp you might be lucky with one more Y-cable. Maybe you could build one. It might be possible, but a LOT of work (only 15 small wires in a cable?).
Maybe the KVM switch is exactly the same thing I wanted to build. If it transports all DDC and other informations (cloned them), maybe the computer wouldn't even know there were multiple screens...
A problem could be the power provided by the cable and needed by the Displays
If all were e.g. side by side or over under or Pageflipp you might be lucky with one more Y-cable. Maybe you could build one. It might be possible, but a LOT of work (only 15 small wires in a cable?).
Maybe the KVM switch is exactly the same thing I wanted to build. If it transports all DDC and other informations (cloned them), maybe the computer wouldn't even know there were multiple screens...
A problem could be the power provided by the cable and needed by the Displays
Play Nations at WAR with this code to get 5.000$ as a Starterbonus:
ayqz1u0s
http://mtbs3d.com/naw/" onclick="window.open(this.href);return false;
AMD x2 4200+ 2gb Dualchannel
GF 7900gs for old CRT with Elsa Revelator SG's
currently 94.24 Forceware and 94.24 Stereo with XP sp2!
ayqz1u0s
http://mtbs3d.com/naw/" onclick="window.open(this.href);return false;
AMD x2 4200+ 2gb Dualchannel
GF 7900gs for old CRT with Elsa Revelator SG's
currently 94.24 Forceware and 94.24 Stereo with XP sp2!